VehiclesFashionRecipesBlogsHuntTravelsSportFunHandmadeITEducation
Mini-Games
x

x
zakruti.com » Auto & Vehicles » Mighty Car Mods
How To Install A Headunit

How To Install A Headunit

FBTwitterReddit

video description

Rating: 4.0; Vote: 1
This episode the boys from Mighty Car Mods show you how to install a headunit so you can bounce along with some hot tunes without blowing fuses and starting fires!
Date: 2020-07-07

Comments and reviews: 10


Pioneer has the smallest capacitators, so your long THIN wires will drop the voltage when you play at high volume.
You should at least bypass the negative wire from the harness and create your own much thicker wire.
I have auto start/stop on my Lopu 3L and my radio kept turning off shortly when the engine restarted at crosssections.
A small capacitator 3 wires and a diode cleared that and gave me better sound too.
Dont know about JVC, but the thin long wires will drop the voltage.

reply

i work as a mechanic i used to always solder using a gas cordless soldering iron
i was rewiring connections when one of my work mates distracted me for a few seconds at which point i burnt my hand dropping the solder iron underneath the drivers seat it made a mess of the carpet
ever since then ive cripped all my wire connections it's simpler, safer and gives a better lasting connection
though is more expensive

reply

Don't ever, ever, ever solder anything when it comes to cars, you don't ever see car manufacturers solder a dam thing on cars, on cars soldering is a major NO NO, Marty still don't get it threw his dam thick skull of his. i've been an certified automotive tech for over 10 years and i've never solder anything or any type of wires into car or have ever seen anyone do it. I don't know, it must be something wrong with ya australians.
reply

It let's you watch video all the time. The parking brake switch grounds the warning light on the dash to illuminate it, the warning light is live (positive) with the ignition on. The head unit uses this switch to find a ground, when there is no ground the head unit knows that you're driving and cuts video.
reply

Or just simply take out the new stereo from the box take apart the dash, take out the old stereo match up the new wires with the ones in the car butt connect them make sure the red, yellow, black are connected first. After that just simply put everything back in tune your stereo and your good to go.
reply

You guys should do a video on how to install an AUX port in your car (not sure if that would require an aftermarket radio/headunit. I just bought my first car an it doesn't have an AUX port. It's a post 2000's car too. Being at the drive thru with none of my tunes is depressing: '-(
reply

Don't solder it in the car. Solder the harness inside or wherever you do your soldering so you can set up proper ventilation. Also, I'd put female USB ports where I want the iPod to go. Then I can use anything that can connect to USB.
reply

Its easier to buy pre made adapters and they aren't too much from ebay. If you want to play videos while driving all you need to do is connect the handbreak cable to any earth cable or even tape it to the metal side of the headunit.
reply

Hi guys great video, my question is what would cause a multifunctional head unit like that to stop operating after about 10seconds? Is it a wiring issue or is the head unit cactus?
It's in a jdm s15 too

reply

How do I fix sound delay. Like when I'm waiting in a parking lot and watching YouTube, the sound is behind/ delayed a second or two (with MP3) if I use an aux cord, it's fine. Should I replace the unit?
reply
Add a review, comment






Other channel videos